Recent Posts by philsom68

Subscribe to Recent Posts by philsom68 206 posts found

Pages: 1 2 3 4 5 6 7 8 9

Nov 18, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Bridgestone j33 combo + wedges - $400

What shafts are in them and are the wedges bridgestone?

 
Oct 15, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Equipment / Precept U-Tri Extra Spin $20/doz

Very good ball and worth a try at that price. Used the U Tri Extra Distance a lot at they are very good combo of length and spin.

 
Jul 28, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Ask Golf Guru - Golf Instruction / Flat vs Upright

How did you get your iron set setup when you went for a fitting?

Will persevere with a faster body as I need more speed -similar handicap golfers at our club are 30m past me. Went through the dynamic fitting process so irons are upright – 64 degree 5 iron.

 
Jul 28, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Ask Golf Guru - Golf Instruction / Flat vs Upright

My experience. Have been playing for 4.5 years and am down to 4hcp. I am self taught but have had one lesson a year ( mainly to use my ball rundown money) with 4 different teachers so 4 lessons in total. My swing is quite flat and the each of the last 2 teachers have told me to get my swing more upright, but when I try to do this all that results is push/cuts and the control is just not there.

The consistency of the upright swing is just not there “for me” with lots of cuts and pushes. So I always revert back to my natural swing as it allows me to be consistent. Whilst my swing is short, at least I am on the short stuff but another 20m would help off the tee:)

I will try a quicker forearm rotation. However when I try and quicken my body up I end up pushing the ball more ofetn than not.

The only negative for me, and I not sure if it is consistent with flat swingers or if I get a bit flippy, is that my contact is sometimes skinny.

 
Jul 25, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

Gee that was quick – delivered at 9.40 and at the range already – hope you enjoy it.

 
Jul 20, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

No not sold yet. I am in Brisbane – you can email me swaussie at tpg dot com dot au and I can give you all the details and get your details

 
Jul 16, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

I am yet to hit a ball with it – once I sat it down and noticed that it was slightly closed I knew it was not for me. I was a bit disappointed as I bought it on the assumption it would be square – I have no trouble squaring up the clubface. I have written to Nickent to tell them it is not square so will see what they come back with – unfortunately got it from the US so I am not too hopeful of a positive response. I am selling for less than what I paid for it – I obviously got from the same place as Dazza.

 
Jul 16, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

Note mine is the Tour Square

 
Jul 16, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

Hi Guys – here is the blurb from Golf About:

“3DX Tour Square: The 3DX Tour Square had a neutral face angle and a black, ion-plated PVD finish. The latter is just cosmetics; the former makes this the version of the 3DX square driver likely to be preferred by better players. That’s because the square face angle, slightly more face progression, plus its bulge and roll characteristics combine to produce a lower, more penetrating trajectory. The 3DX Tour Square is also available in lofts of 9, 10.5 and 12 degrees”

I will be honest with you – if this sits square I am a monkey’s uncle – it does to me sit a little closed to my eye compared to my Titleist driver. Apparently the tour version does not sit as closed as the normal 3dx square.

 
Jul 16, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Equipment / Driver Help

A good driver, possibly having the NV shaft which is tip stiff may not be helping. I have had a few troubles with those shafts not being the right flex. I would suggest seeing a fitter who can test the shaft to see what flex it actually is. If it is ok and a true reg flex, then they could re-shaft it with a shaft more suitable to your swing. This will be cheaper than a new driver – once again the 905r is a great driver.

 
Jul 16, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

Price drop $120 shipped – almost the cost just for the Proforce shaft.

 
Jul 15, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / WTB Titleist 3-48 54 58. Ec 8-9-10/10

$160 shipped

 
Jul 14, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / WTB - Dynamic Gold SL S300

Pm sent to you somewhere else.

 
Jul 14, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / WTB Titleist 3-48 54 58. Ec 8-9-10/10

I have a 905t with a graphite design ys6 stiff and a 905s with stiff speeder shaft both 9.5 deg and both in very good condition. Any interest?

 
Jul 14, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / WTB - Dynamic Gold SL S300

Just about to get some pulled out of a set of irons – .370 though – sorry.

 
Jul 9, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Ping Rapture 10.5 Head only. $225

Watch out for Ollie mate. He committed to buy some irons from me here and said coin would be available in a week and after many emails and holding onto the irons for him he has not responded to emails, over a month has passed – bad form from a ISG member.

 
Jul 6, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Nickent 3DX Tour Square Driver New - $130

NEW NICKENT 3DX TOUR SQUARE 10.5* DRIVER WITH UST V2 PROFORCE STIFF SHAFT.

$130 which includes shipping.

 
Jun 30, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / TaylorMade r7 460 TP 9.5º Stiff - $200 or trade

Got a 905s with a stiff speeder shaft if you are keen to trade?

 
Jun 29, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Wilson Fi5's Brand New

Sold!

 
Jun 29, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Wilson Fi5's Brand New

Last chance – crazy prize – $300 plus shipping

 
Jun 26, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Wilson Fi5's Brand New

Any offers before they head to the bay???

 
Jun 23, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Wilson Fi5's Brand New

Due to a bungled order I have for sale a brand new set of Wilson Fi5’s. These are still in plastic and have not seen the light of day.

Set is 3-Pw and they have DG S300’s in them.

$400 plus shipping

 
Jun 21, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / WTB: Irons set - looking at $800 (max!) for decent set

I have a set of Snake Eyes 600c’s. Also included is a 52/6 gap and 56/12 (bent to 57/13) sand wedge – both Snake Eyes 600W’s.
Condition of sand wedge 6.5/10 and the rest of the set would be 8/10.
The have Dynamic Gold SL S300’s in all clubs (the wedges have been made to a wedge flex) with Lamkin Crossline Midsize grips. Irons are 3/4 inch over standard ( 38.5 inch 5 iron).
So all in all a very good set of irons which are forged with a shallow cavity – 10 irons in total and am looking for $400 plus shipping.

 
Jun 5, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Snake Eyes 600c 3-PW plus 600w 52 and 56 wedges

No worries. swaussie at tpg dot com dot au

 
Jun 4, 2008
Iseekgolf_80 philsom68 206 posts

Topic: Golf Classifieds / Snake Eyes 600c 3-PW plus 600w 52 and 56 wedges

They sure are. For the record I still use the same set just with normal DG s300 shafts so these need to go.

Next page

Pages: 1 2 3 4 5 6 7 8 9