I am looking to upgrade my old set of x14 & launcher 460 and I narrow down to these two options:

G10 & TM Burner or
MX25 & TM Burner

Anyone played these clubs and what is the opinion?

you cant compare mizuno to ping , mizuno is by far a superior club .

I have recently upgraded (in last 3 months) I have gone srixon i-506 irons and TM Burner

The burner is a great big forgiving head that goes a mile and srixon irons are accurate forgiving and good looking irons

Yeah leave ping alone…look ping make great clubs but for the same dollars you can buy mizuno, titliest and other top irons

Its simpler than “this is better this is worse”.
ping use a hard metal to make their irons. In g10 its combined with some offset, a wide sole and a hollow cavity. the hard metal will detract from feel but reduce slices/hooks dramatically compared to the srixon and MX-25 irons which are forged club. Forged is what people rave about for its feel but it will enhance workability (sidespin) as it increases feel. If you’re a graphite shaft man, forgiveness really isnt an issue because the shaft will take care or it. So if you have trouble with unwanted sidespin on your iron shots, g10 in a graphite will let you hit it straighter while the hard metal and ball technology will stop the ball on a dime on the greens.
Srixon and Mizuno will feel a bit sexier, especially if you go for project x’s in the mizunos, but they wont straighten out your ball flight the same as pings. If you’re a steel shaft man, I’d go for mizunos. If graphite, g10’s